| 1. | Modelling of unit power plant load system based on rbf neural network 神经网络的单元机组负荷系统建模研究 |
| 2. | Bevel gear units power gear units 螺旋锥轮减速机 |
| 3. | Blue unit powered , ready to scan ; white good read ; yellow in stand 蓝色上电,准备扫描白色解码成功;黄色支座中 |
| 4. | Air consumption per unit power 单位功率耗气量 |
| 5. | Effect of condenser pressure variation on unit power increment calculation 凝汽器压力变化影响机组功率增量计算的研究 |
| 6. | The pink tiger made of bronze 300 cm high with its base units power , serenity , strength and movement 此雕塑为高3米铜刻,与它的底座衔接表达了力量,神圣,冲力和动力。 |
| 7. | According to the development of the direct air cold technique in domestic , at present , the pretiminary condition is qualified for build a direct air cold test unit power plant 根据国内直接空冷技术的发展情况,目前已初步具备了建设直接空冷试验机组的条件。 |
| 8. | So far as the basic unit power supply enterprise is concerned , it is can also rapidly promote the comprehensive management level by the benchmarking in the colleague industry 对基层供电企业而言,在同行业内通过对标可以迅速提升综合管理水平,在国家电网公司体制变革的今天这显得尤为重要。 |
| 9. | The article mainly concentrates on the following points : ( 1 ) with the case of homemade 300mw unit power set , the principle , mathematic - model and dynamic characteristic of the unit power set have been analyzed 本文的研究主要集中在如下几个方面: ( 1 )以国产300mw单元机组为例,分析了单元机组的原理和数学模型及其动态特性。 |
| 10. | The contributions done are as follows : according to the mathematical model of doubly fed motor and the theory of vector control , a unit power factor of rotor control scheme is proposed . in the doubly fed adjustment system , in order to control magnetic torque of motor this scheme is designed by controlling the reverse direction between rotor voltage and current to keep the vertical direction between rotor current and flux . it is known from theoretical analysis that for partly decoupling this scheme is only effective under sub - synchronization speed , but not control the system and obtain steady state since speed adjustment system ca n ' t adjust the magnitude of rotor flux under sup - synchronization 而传统的无速度传感器双馈调速矢量控制系统,由于采用磁链定向方法,在同步速附近存在较大的工作死区,针对上述问题,本文做了如下的研究工作:本文从双馈电机的数学模型出发,根据矢量控制的基本原理,提出了一种转子侧功率因数为1的双馈电机矢量控制方案的设想,即在双馈调速时采用转子电流定向的方法,并控制外加转子电压与转子电流始终反相,以保持了转子电流与转子磁链矢量垂直,通过控制转子电流的大小来达到控制电机电磁转矩的要求。 |